Anyone using Arizen seats

[arizen]

EDIT: Two observations that might help others. I wanted these seats as low as possible so I did not install the spacer nuts provided from arizen between the sliders and seat. So when I pull up on the slider adjuster it's a little tough to slide the seat sometimes since the adjuster has less upward travel before hitting the seat cushion.

Chad,

If you remove the slider pull bar you can easily adjust it so you can pull up without hitting the seat bottom. Just put the pull bar in a vise and change the angle slightly where it attaches to the slider. Being tubular it will adjust easily and once you get the handle to sit lower in the front you will be able to pull up without hitting the bottom of the seat and the sliders should slide freely.

Mark