Picked up a "new" project...

[astroracer]

Just a bit of an update. Haven't gotten a lot done on the truck other then stripping down the donor truck and getting the underside of the floors cleaned up, rust converted and painted.
I used the Eastwood two part Rust Converter and was impressed with the ease of use and the job it did on what surface rust was left after I power wire brushed the floors.
This first photo was taken after I had done the upper half with the wire brush. I used a knotted wire cup srtyle brush mounted on one of my angle grinders. Wicked...

After coating the top half...

With all of the floor done, I waited about an hour and then sprayed the floor with some cheap red enamel I found at Big Lots... Yea, I know it's not show quality but it will do the job to protect the floors and is much better then what I had...

Thanks for looking.
Mark