1965 Chevelle Project!

[Rantheman]

I better hurry to get the to the shop before it rusts to much!

[Rantheman]

well some of you havn't had a chance to see it yet but I am a lot further then m last pics I am just throwing them out little by little maybe this will show better.

Back From the Powdercoating shop

[Rantheman]

This is a pic the The Rear end in place with the summit rear end griddle. And my Metco Upper and lower Trailing arms

[Rantheman]

SO a few days Later I decided to install my SS brake lines and my SS fuel line with my Rear air bags and eibach springs and shocks

[Rantheman]

Then figured it was time to get that rear end together now from my mini tubb I also had to cut the rear end down and did it successfuly. My rear end contains richmond 4.10 gears,eaton 3 seiries posi,moser 30 spline alloy axles,ratech install kit, toped with a moser 1350 yoke

[Rantheman]

After the rear end was completed I decided next was to pay attention to the front end. On the rear I only lacked brakes but the front I already had most parts sitting around which are

Global west upper arms
Global west lower arms
Hotchkis 1 3/8 sway bar
AGR quick ratio steering box
all new steering.
B-Body spindles
Eibach springs
kyb shocks

[Rantheman]

now for the last part of my progress The rear brake are on but I have no money right now to put front brakes on and wheels and tires all around. I got the body in the garage and started taking out the bad parts and going to also finish up my mini tubb.




sorry frame is a little dusty

[novanutcase]

Looking Good!!!

John

[Rantheman]

Looking Good!!!

John

Thanks John!

Randy