Looking for G-Body Frame Notch Info

[redss86]

I went to the factory seam on the frame rail which I believe is around 1"-1.5". Probably closer to 1.5". So the wheel wells will be moved in the same amount.



Not much. Maybe an inch or so.



The 315's fit perfectly fine without the flares. In fact, with the flares, the 315's look a little too narrow. Or at least to far tucked in. The fender lip might need some minor clearancing or rolled completely. But you should be able to get them to fit without needed flares.

Cool, Thanks for the info. I was planning on cutting some of the 1/4 lip off so I should be fine. Looks like you are doing alot of work, but it all looks great.

Good luck