86 Monte Carlo SS super project

[redss86]

Here are some pics of the rear floor board. I have a minimum of 1/4 clearance from the floor to any suspension part w/ the suspension completely bottom out against the frame. I know this isn't much clearance but unless one of the arms break or a grade 8 bolt breaks I shouldn't have any problems. I don't remember if I did the floor mods w/ the body bushings installed or not. If not then that will give my even more clearance. I am pretty sure I had them install, and they are brand new urethane ones from Energy Suspension. I figured if I could get clearance w/ the suspension bottomed out against the frame, then once I installed some sort of bump stops I shouldn't have any problems.

Here are the pics, as you can tell they are still in bare metal and need primed. The welds also havn't been finished on the bottom.