86 Monte Carlo SS super project

[redss86]

Future state I plan on adding either light weight I-beam or tube arms. Current state is factory arms. One idea I had was to light them was by drilling 1” holes down the length of the center. Does anyone have an opinion on this????

I don't know how well the i beam or tubr arms would work. The truckarms are built the way they are because they have to flex. I think if you use an I-beam or tube setup, it would cause some serious binding issues. I have seen somebody (think it was on this website) that used a set of tubular arms. Though the way they had them built, I don't think it necessarily saved much weight. From the research I have done, you can't run a truck-arm setup w/ arms that are torsionally rigid. Here is a link to a very good discussion on a tubular truck arm setup. There is a ton of info in this post. http://https://www.pro-touring.com/f...lar+truck+arms

As far as drillin holes to lighten the arms, you might be able to do that. I would just me concerned about the strength afterwards.

Just my thoughts,
Joe