The BAD AST Project - Faze II

[astroracer]

Not much to report. I spent Monday and Tuesday evenings rebuilding the lawn mower deck. Last nite I got some new pieces cut out for the rear rail/front rail interface.
The pic below is of one of the rails I got from Alston. Ran into some problems with those not being "linear" around the bends...

The front half of the RH rail is .50" lower than the rear half. Not a show stopper, it just creates a set-up issue that has to be taken into consideration. The LH rail is different from the RH so it will require a different set-up.
The spring hangers are not dependant on the rail height. They register on the bottom of the crossmember which is still square to the table.