The BAD AST Project - Faze II

[astroracer]

Thanks a lot guys! It sure does feel good to be back on this.
I got the front line ran today. A flare, 2 bends and a few clips and it is in place.

I made a little sketch to get the bends in the right spot.

All clipped in. I put the clips on 12" centers. Seems to support the line very well. I need to terminate the end of course, but I can't do that until the front suspension is mocked up. I'll do that along with the rear.

Had to a little re-routing to get around the motor mount tubes. Looks okay? or not...


I used the tubing straightener I built a while back to get all of the lines straight. It works like a champ.

I also spent some time figuring out where to put the soft line tabs. I need to weld one to the rear shock cross member but want to verify rear end travel before I do. You can see the layout lines above the shock mount hole in the cross member.

I will be assembling the rear suspension so I can run it thru it's travels (and finish the shock mounts. ).
Mark