The BAD AST Project - Faze II

[astroracer]

Got out today and got the lines plumbed. This was a bit of an adventure getting the tight bends that were needed to run the lines.
I ended up making a little bending fixture to get it done. This will be pretty handy for doing the rest of the van.


I made the clamp block on the mill. Both ends have their uses and I used both getting the bends into the lines.


The line for the rear brakes is in.

And here is the line for the front brakes.

This is one of the double flares I do with my CPP Flaring tool.

Got a lot done today and I am pretty pleased with the bending fixture.
Mark