Results 1 to 1 of 1
-
06-25-2006 #1
motor/trans angle for tremec swap
I put the tremec in using the stock th400 crossmember moved back in my '71 chevelle. I haven't measured the angle because I can tell it's too much just eyeballing it. My question is, should I try to get the motor/trans parallel to the chassis? I know I should shoot for a max 3deg. angle at the u-joints, but if i'm moving the trans mount up anyway, the option is there. Looking at it now, the trans is pointing downward, so for proper driveshaft alignment, i'd need a positive pinion angle. I've researched this a bit and it seems there are a lot of different views on pinion angle issues. I have seen a lot of tube chassis cars built with the crank set parallel to the chassis. That way, I can have a slightly neg. pinion angle which I think is beneficial.
-



Reply With Quote



