Turn signal blowing fuse

[rockdogz]

I'm just getting my wiring going and have hooked up the taillights (using LEDs) and front lights (not using the front turn signals, so have run those wires to ground). At first the turn signals wouldn't flash, so I got some electronic flashers. Now, the turn signal goes on once and the turn signal fuse blows. Any ideas?

[rockdogz]

Figured it out.... I had run the front turn signal wires to ground since I wasn't going to use them, but then I ran them to the front parking lights instead and they flash just fine.

[Madspeed]

hehe
I was gonna say you ran you wires to gnd =)
You may have heard that you need to gnd the lights to make them blink with led's

You can do that but you need to use a large watt resistor thats the same ohms (resistance) as the bulb =)

oh and im in so cal to if you need assistance =) im pertty slick w electrical =)

Gl Ken F