Results 1 to 4 of 4
Threaded View
-
02-02-2006 #2
Full Blown G-Machiner
- Join Date
- Nov 2004
- Location
- Roanoke, VA
- Posts
- 515
Im assuming that youre talking about the tail shaft housing portion where the speedo gear is located? If so then they dont have the same bolt pattern since the 200 doesnt have any bolts holding the tail housing on.....the 200 has a one piece case front to rear
.
HTH
GMC Syclone (currently wrecked thanks to the typical rubber headed VA driver not paying attention to his red stop light...oh and he didnt have insurance either)
#614 11.9 @ 113
New stuff finished 08/06:
4L80E trans w/TCI PCM
Front: J&S UCA/LCA, QA1 coil overs
Rear: Caltracks/Belltech drop leaves
Empire drive line alum drive shaft
Polished 17x9 F/17x11 R ZR1s with 275s/315s
Syclone
Tow rig
-
Reply With Quote
