License plate angle

[Jim Nilsen]

I know it's a bit more work and it isn't what you had in mind but while looking at the last pic I visualized the plate right back where it was originally and the pipes being one on each side of the plate. You wouldn't have to modify your bumper and you would still achieve the pipes in the middle of the car, just not next to each other. I still haven't seen anything like what I am describing and from what I can see it would fit within the sheetmetal you have already replaced.

If it only took you 3 hrs to do the area for the pipes now it should be a breeze compared to the problems you have to solve to complete what you are doing now.



Remember that this is just a thought of what I just saw when looking at the pic. I think it would still look great with a pipe on each side of the plate.


Goodluck and it is looking good so far!
Jim Nilsen

[CAMAROBOY69]

I appreciate your advice Jim but I have wanted to do my exhaust side by side out the back like this for 3 years and I will do it. I am just soo stubborn like that. If I visualize something then I WILL do it one way or another.
Its only metal so I will figure it out. One of my ideas is to sink in that top body line just above the bumper. That line sticks out the most at least 1/2". So if I trimmed that then I would gain a lot. I will try to get a pic posted up in my exhaust thread of what I did last night. If you look at my recent pics again you will see the line I am talking about trimming.
Thanks for the feedback and compliments.