Results 1 to 5 of 5
Threaded View
-
09-06-2023 #1
Registered User
- Join Date
- Nov 2016
- Location
- Sulphur, La
- Posts
- 612
Dump hydraulic throwout bearing question
I have never had anything with a hydraulic clutch and I have (2) easy questions:
The throwout bearing has 2 lines coming from it. One goes to the clutch master but where does the other go?
My setup is a Tilton adjustable throwout with the GM Camaro master on a DSE bracket for a 69 Camaro. This clutch master comes with fluid in it so I assume it to be bench bled. The lines both have a rubber cap on them but inside the fitting is a plastic piece, does this plastic piece get removed? I noticed that you can not compress the master so I assume something has the fluid trapped.
-
Reply With Quote
