Ridetech 4 link opinions

[Sinnister69]

So ive actually had my 4- link for about 11 years now and today i went to mock up my new moser rear housing.
Per the instructions that came with my kit it states to raise the housing to ride height or the equivalent of the shocks at a length of 14-1/2”-15” eye to eye. Check



I made a jig back then out of aluminum square tubing with an eye to eye measurement of 15” dead on
Next upper bar jigs eye to eye 9-1/4” eye to eye. Check

Lower bars set at 24-3/4” eye to eye check

Housing and car level check

Pinion angle was 2-1/2° up but that souldnt be causing my problem or if it even is one

My question is that the upper bar tabs are laying on the axle tube way too towards the back of the car.

When i first installed the 4- link 11 yrs ago i the tabs layed nice on the axle tubes

Any advice or opinions are greatly appreciated