Starting a Build - LS Swap 69 Camaro

[MTBSully]

Awesome build. Car came out great. 2 questions:

1. Is your window trim painted or powder coated gloss black? Looking to do the same.
2. Where do your seat belt harnesses attach to?

[lbsurfer11]

Thanks so much for the compliment. Not the most extreme of builds for sure but best I could do with hand tools and an air compressor.

I got everything powder-coated cause I live on the beach in Florida and it protects a bit better than paint.

The belts connect to the bolts of the rear seat belt. I did a ton of research and you can find links on this forum as well. Schroth Ralley 4 is DOT-approved and uses the anti submarining tech that helps you avoid sliding under the lap belt. Look them up and give them a call they are super cool guys and the customer service was great.

[MTBSully]

Thanks so much for the compliment. Not the most extreme of builds for sure but best I could do with hand tools and an air compressor.

I got everything powder-coated cause I live on the beach in Florida and it protects a bit better than paint.

The belts connect to the bolts of the rear seat belt. I did a ton of research and you can find links on this forum as well. Schroth Ralley 4 is DOT-approved and uses the anti submarining tech that helps you avoid sliding under the lap belt. Look them up and give them a call they are super cool guys and the customer service was great.

Thanks! I was thinking of powder coating as well but was curious if the added thickness of the PC would led to any difficulty at re-assembly.

Any more pics of the seat belt setup, front and rear? Are your rear seats still useable?