1979 "Transmarrow" Mid-engine LQ9 build

[jlcustomz]

Is the front going to be near that wide also? Didn't realize the back wheels would be so wide.
It'll definitely be hard to make that much stretch look good in that short of a space.
This was another hair brained thought of an option since the body is pretty much a floorless shell anyway. Split the roof in the center, stopping the cut at the front windshield framing. Then slice the rear about an inch outside of the trunk line. Then you can flare the back out maybe 2 to 3"" per side at the rear door opening area. Then slice across the top of the quarters at the center of the new wheel opening, which will be roughly 70% wider than the width gain at rear of doors. Then taper rear half of quarter back a little and make the rear 2 to 3" wider per side.

Just a thought that I been thinking on a while here. Would definitely give an aggressive look fitting to a mid engine car & make the flairout area at the wheels themselves less ridiculous looking. Since you have a floorless shell, this could be less work than it sounds like for the result it will give you, especially considering the difficulty of making that wide of a body flaring job look good.

If you want to consider this option, take me a better high view picture of the top rear of the car. I know someone with a pencil & paper.