Enter your username:
Do you want to login or register?
  • Forgot your password?

    Login / Register




    Results 1 to 4 of 4

    Threaded View

    1. #2
      Join Date
      Mar 2004
      Location
      Mid-Michigan
      Posts
      2,764
      Country Flag: United States
      Keeping track width inside the "inner" bearing dimension is a good thing. Having it the same or slightly wider is relative to what you are doing with the car. The lever load on the bearings is what you want to keep lower and having the "fulcrum point" inside the bearings lowers that load. Altering the offset of the wheel so the offset is equal to or more then the width of the wheel will keep the fulcrum point, or track width, even with the inner bearing.
      As an example:
      I am using 17 x 10 front wheels on my van build. When I designed the suspension I designed the track width around a 7" offset on those wheels. This, of course, pushes the spokes out to the outer lip. A lot of guys don't like that look but for bearing life and suspension design this is what I needed.
      Same thing in the rear. I have 18 x 12's back there with the same 7" offset as the front. This puts the fulcrum point 1" inside the wheel mounting face and about even with the outer axle bearing. Reducing load and hopefully increasing bearing life.
      mark

      Mark:
      "Bad Ast" Astro Van. Just because I did it... Doesn't mean it's possible...
      This my Bad Ast thread...
      https://www.pro-touring.com/showthre...roject-Faze-II
      This is my Fotki album...
      http://astroracer.fotki.com/





    Advertise on Pro-Touring.com