Jimmy GT, '92 GMC forever project

[SonomaZ]

Fabrication to look forward to in no particular order:



Floor cut out of cab / body drop. Original plan was to have the rocker just above the bottom edge of the frame. Might bring it up a bit.
8" of engine setback / firewall rework.
Engine and transmission mounts, transmission cross member, d/s loop and torque arm front pivoting mount.
Full-(ish) cage.
Front wheels widened to 10" (Send out to Weldcraft, they did the rears already.) 275's or 285's on the front.
Body mounts.
Additional frame section behind axle for body mounting and fuel cell.
Seriously considering flaring the fenders front and rear, all steel.
Millerbuilt C7 full floater kit and axles once axle housing width is determined.

[Hotwire]