'Streamline' 1968 camaro project

[slimjim]

So another project on my mind for a while got some attention today. Ages ago I bought the 4.5" Truck-lite driving lights which are made to match the 27270C headlights. But I couldn't figure out how to mount them and to buy a set of the fester billet mounts and re-work them would be an expensive experiment.

Well since these driving lights are most common for Harleys, I decided to get some cheap Harley pods and trim pieces from Ebay. So for about $18 I have these trim pieces that are sort of close to the 69 valance curve. They're far from perfect but I think with some nice tabs welded on the inside I should be able to get them to mount up pretty nice.



This is before I cut out the original mounting bracket






And after.




I also found what could be a very nice PCM location. This would sit directly behind my double din display, should get great ventilation and "shouldn't" intrude with the vintage air I am yet to purchase, and best of all, it is directly above the grommet where the harness goes through the trans tunnel.

I chose to use the dirty dingo E38 PCM bracket