'Streamline' 1968 camaro project

[slimjim]

Today i got my rear end away for narrowing. and once the official measurement is clarified I will order a center section and axles to go with it.
Several issues are holding my car up right now, which will hopefully lead to exciting news in the coming months, but I decided to put a couple hours work into the interior after getting a lot of help and motivation from john aka cryptonomad.
initially I just wanted to size up the steering column and look into the U-joints to fit my R+P, but hey presto none were required, then after removing some tabs and some minor trimming of the 2012 dash framing we managed to get quite close. The column isn't quite bolting up to the frame, It's about an inch off, but the frame isn't quite in place yet, some serious trimming and work needs to be put into the trans tunnel, and everything needs to be lowered about an inch, but all in all not bad for an hours work.