Enter your username:
Do you want to login or register?
  • Forgot your password?

    Login / Register




    Results 1 to 2 of 2
    1. #1
      Join Date
      Oct 2005
      Posts
      16

      3.8L turbo v6 swap

      Is there anyone here who has swapped a grand national turbo v6 and 200r4 into a first gen camaro? I recently picked up a 69 camaro- no engine/tranny and I am looking into this swap. I was also considering an ls1/t56 swap, but I am really experienced w/ the grand national v6's.



      I am thinking the hardest part will be the motor mounts to frame mounts. Just checking to see if anyone has seen or done this before.

      Thanks.


    2. #2
      Join Date
      Nov 2004
      Location
      Roanoke, VA
      Posts
      515
      Have you checked the www.turbobuicks.com forum in the hybrid/engine swap section? Its been eons since I visited that site but Id put money on there being some helpful info there.

      You might also try http://www.nastyz28.com/forum/index.php as it seems I remember seeing some factory base model V6/2bbl camaros and Im sure they could tell you where to procure the motor mounts and other do dads.

      HTH
      GMC Syclone (currently wrecked thanks to the typical rubber headed VA driver not paying attention to his red stop light...oh and he didnt have insurance either)
      #614 11.9 @ 113
      New stuff finished 08/06:
      4L80E trans w/TCI PCM
      Front: J&S UCA/LCA, QA1 coil overs
      Rear: Caltracks/Belltech drop leaves
      Empire drive line alum drive shaft
      Polished 17x9 F/17x11 R ZR1s with 275s/315s
      Syclone
      Tow rig


    Advertise on Pro-Touring.com