Need help with engine direction.

[Wflohr]

Ok guys its getting close to start putting the motor together but I need some advice. The motor my grandfather was building was originally intended for the strip but I am making it for the street. I don’t know if I should just get a new cam and rollers, or keep it and get a better torque converter. The cam is mechanical and I figure it would her easier with a hydraulic. The specs of the motor are as follows:


Cam L88:
.540/.560 Lift
334/364 Duration


Pistons TRW L2337:
.30 over
12.5:1


Heads:
Casting Number 6272990
454 71-94
2.19/1.88
118cc Rectangular Port 325cc Intake
Open Chamber


Torque Converter:
GM23
2600 Stall


I know if i keep everything on the motor I am going to need a better torque converter but if I change the cam I wont need to. I saw someone on another forum did the same heads and pistons together and got a 10.6:1 compression with a 4.345x039 head gasket but thats also with unknown cam. Any advice or opinions?