68 camaro Ridetech front subframe pictures???

[paulk68]

I was wondering if anyone has a good set of detailed photos of a 68 camaro stock front subframe with the ridetech level 2 kit installed including tru-turn. I feel like i am in a sea of parts and am defanitley a rookie builder. I was really hoping the ridetech directions were going to be a little better but to a rookie builder they are pretty vauge. I was hoping some of you had some good color photos you could pass along. If you think you can help send me a pm and i can shoot you my email address.
Thank you

[Bad94]

What photos are you looking for.

[shmoov69]

Directions?!?! Mine said in bold "DO NOT OPEN".... So I didn't!! LoL!

Sorry, I didn't take pics but what do you need?

[paulk68]

Thanks guys, nothing specific I guess I just want to make sure that I am installing everything correctly. I tend to over think everything. haha. On a side note a few questions I do have that maybe you can help is.

1. I am installing this on a clean bare epoxied subframe, I am doing the initial install to check to make sure everything fits together nice first before I disassemble it all and paint the frame. obviously I will wait to add the loctite until final assembaly but is it ok to install everything else like normal with all the nylon nuts and everything?

2. The car will mostly be used for street but I might get to an event once or twice, will I be missing out on anything if I install the upper arm caster cross shaft for a street driven vehicle as apposed to a full on track car?

Thanks again

[Bad94]

I will try to remember to take some pics on my car today.

[Josh@Ridetech]

Hey Paul,

Longtime, no talk .

Did you get this fixed on your car yet? Here are a few pictures to go off of:

[xavier296]

I just finished my install on a 68 camaro, so if you need specific pics, let me know. I only put a few things on backwards the first time!