Auto Rod Tech's metal shaping and fabrication thread

[Auto Rod Technologies]

I'll check out the project right after this.. Here's a little update on the 57' I would do a whole project thread on it but it's really not pro-touring at all so I don't want to take up a whole thread on something not Pro-Touring related. However putting it here is still a good way to show some of our work.. The process we are going through right now is no different than what we would do on any car so it still fits in some aspects.

Here's some pics of the 57' the quarters are welded on and body lines are set, this was no easy task, it was a fight getting the body lines as nice as they are with very little cutting, the back end by the trunk was a royal. P.i.t.A. we still need to do some fine tuning work but we get everything as close as we can without panel modifications. Or as little as possible in this case. then we go back over the whole car to make adjustments to the sheet metal to get everything how we want. Very time consuming process.