"Sloper"

[Matt@RFR]

It's a fixed setting that results in fixed travel speed if you're using it to time filler deposition. To me, it's extremely hindering to use the pulser in that regard. You'll get the same look if your filler deposition is consistent in both timing and amount deposited, but with much more control.



I use my pulser in only two scenarios: 1) Thin and/or heat sensitive material to keep overall heat input down to a minimum, usually 150-200pps, and 2) autogenous welds on stainless. The picture shows the result of the latter on the tube-to-tube cap weld. Just set the pulser, set the RPM of the positioner, clamp torch, hit both pedals and wait for it to finish.