Modern Bullitt Charger build

[keepat]

Fit and tack welded the right front torque box. Had to bend the US Car Tool torque box on an angle and added ¼” along the floor side to get a good fit. Both sides will need the same alteration to fit correctly.

Thanks
Pat

[keepat]

Installed the parking brake cable pass-through tube in the frame connector. I also remove the original floor mount for the parking cable as I’m going to install a small roller to redirect the cable along the frame.
Thanks
Pat

[apstewart]

This thread is amazing! I always look forward to your new posts.

[keepat]

This thread is amazing! I always look forward to your new posts.

Thank you sir, I look forward to working on it ;-)
Pat