Modern Bullitt Charger build

[TimMC]

It takes so much time to do the little details that looks great.

[keepat]

Thank You gentlemen!

[keepat]

Finished the left front brake line and started on the rear brake line. Fuel lines are next.
Thanks
Pat

[wfo guy]

Nice job! Are you going to paint them or remove them when you finish the underside?

[Motown 454]

They look great. Nice work.

[keepat]

Nice job! Are you going to paint them or remove them when you finish the underside?

Everything will come out when I start to do the body work and as the line are 316 S/S that will not be painted. Putting a lot more effort into the pre-paint fitting and installation of all the parts before the body work. I'm hoping it's all going to pay off at the other end of this project.
Thank you!
Pat

[sdg0080]

This thing is going to be an anamal to drive. Your attention to detail is second to none. I may have forgotten or missed it but what are you using to bend the lines?

[keepat]

This thing is going to be an anamal to drive. Your attention to detail is second to none. I may have forgotten or missed it but what are you using to bend the lines?

Most of my mandrel benders are made by Parker but I also have 1 Ridgid bender. And for making tight bends right at the fitting I also us this little Eastwood bender for both 3/16" and 1/4" that works nice.
Thank you!!
Pat

[keepat]

It’s not a ported head intake runner, but it will have fuel running through it. What do you think it is?


Answer will be in the next post
Thanks
Pat

[keepat]

I needed to make a large fuel pass-through in the trans cross member as there will be two ½” fuel lines. I used part of the rear frame rail I cut off last winter to make the reinforcement for the hole I put in the cross member. Now I can bend full length fuel line to fit.
Thanks
Pat

[langleylad]

A ported intake manifold runner

[langleylad]

You posted just before I did !

[wfo guy]

Why does it take so long to build a car? See above. Looks good.

[keepat]

Why does it take so long to build a car? See above. Looks good.

Yep! I'm my own worst enemy ;-)

[Alwhite00]

Great build, Love chargers.

[Motown 454]

Yep! I'm my own worst enemy ;-)

Maybe, but very informative and entertaining! I love all the small details.

[keepat]

I installed the fuel tank so I could mark the trunk access for the fuel pump and sending unit. The tank has a EFI pump inside and adding the trunk access will make it easy check or remove without dropping the tank.
Thanks
Pat

[Motown 454]

Nice, it will end up being flush with the inside.

[keepat]

The fuel tank access cover is done, now I can bend the fuel lines
Thanks
Pat

[Cop Magnet]

Always awesome seeing your updates, Pat.