Enter your username:
Do you want to login or register?
  • Forgot your password?

    Login / Register




    Results 1 to 4 of 4

    Hybrid View

    1. #1
      Join Date
      Jul 2005
      Location
      Eastern Virginia
      Posts
      3,965
      Country Flag: United States

      Is there a rule for how many bends you can have in intake tube?

      Tubing is 4", with 1 60 degree bend & 2 90s.




      Scot
      86 Monte SS



    2. #2
      Join Date
      Jun 2012
      Location
      South Lyon, MI
      Posts
      1,244
      Country Flag: United States
      There is no rule that I have ever heard of. Each bend will contribute to flow loss. But with 4" diameter tubing, losses will be very small, depending on how much motor you have.

      If you are less than 800 horsepower, I would not worry about the design you have shown.

    3. #3
      Join Date
      Jul 2005
      Location
      Eastern Virginia
      Posts
      3,965
      Country Flag: United States
      OK thanks. This design I had, i discovered wont work. Coolant fitting is in the way. Going to have to get a different waterpump with fitting to the passenger side of throttle body, or move battery to driver's side, or trunk.
      Scot
      86 Monte SS


    4. #4
      Join Date
      Mar 2014
      Location
      Sunny SW Minnesota
      Posts
      46
      Country Flag: United States
      I have read that less than 20" cost HP but never understood how that could be. Mine has the same bends you are looking to do with 3 90s and works just fine.
      Jim Stainer
      96 Miata powered by an 02 Camaro SS




    Advertise on Pro-Touring.com