Baer Tracker installed

[Marty G Cars]

Hopefully this will help reduce the bump steer situation that was a result of a previous shop (#@*%!) lowering the mounting point of my rack instead of setting the engine back a bit to clear the oil pan. The shims that came with the kit did not seem to give enough adjustment so I had some made to the maximum limit available for the space, which was 1.09"

I need to try to drop the front end back down a bit with the spanner wrench to get the proper stance. The challenge will be the balance between smashing the headers on the road and getting any of the tire to tuck into the fender.

Then it's off to get re-aligned.

After that all I need to do is finish the hood and install carpet and interior panels. (and get a couple of extra sets of rear tires for the 638 RWHP)