New Chris Alston front sway bar endlinks.

[UNBROKEN]

I saw these at SEMA...had to wait a few weeks for them to start production but they finally came today. Naturally I couldn't resist slapping them in. I had to drill the hole in my lower a-arm out to 5/8" but they dropped right in my Hellwig sway bar.



This is compared to the stock 2012 Ram end link that I added urethane bushings to.



Bad pic but I don't have a good light.




They make a 4.x" version and a 7.x" as well....I guess there's about 1 1/4" or so of adjustment if needed. I ran mine all the way down as short as they would go.
I'm hoping that having no bushings in the front or rear endlinks will improve the steering feedback...guess I'll find out tomorrow when I take it out.