64 Fairlane "Anti Mouse"

[Crazed]

Lucy loaded up, and ready for some metalwork.






New guages



They fit behind the factory plastic



Here we go..

Patches behind the wheelwell lip..




Sigh..





Scotty tossed this on to make me feel better.



Panel went out to be dipped, he will fix the wheel tub area, where the shabby patches were, then he will get it put on.

[Crazed]

Close ups of the removed quarter..








Gas tank is out..

[Crazed]

Getting ready to pull the motor and trans

[Crazed]

It gone!

[Crazed]

Got some new shiny parts.. Wife sez since we are spending so much this car should be driven alot when done, so she wants air.

Since I am going for a classic look on this car, i picked up this..



Mark IV underdash from vintage air

and this..

[Crazed]

All the wiring, brake lines, heater, wiper motor, line lock, all removed to get ready for cleanup.

[Crazed]

[Crazed]

Patterns for new inner fenders





Layed out an "X" pattern but I think I like the vert lines better



Anyone know what these numbers mean and do i need to keep them? They are under the hood hinges.

[Crazed]

Cut out cancer/booty fab from the wheelwell



Cleaned excess metal flanges, prepped to replace the quarter panel.



Inside of the firewall patch



Clip back on to see how things lining up









Set the grille in






Axle gone!

[Crazed]

New Pics...

Axle at the paint shop, having difficulties removing the silver paint..maybe powdercoat?



Replacement inner fender



Clamped in place






Firewall getting welded up (old column mount gone, wiring holes gone)

[Crazed]

This makes my pics current, Headed over tonight to check progress, hoping to have the quarter panel back soon from the stripper.

[MichaelUser]

Looking sweet. Have you thought about putting the windshield wiper under the dash and closing off the engine compartment hole? Just a thought.

[Jetfixr320]

Very nice build. You went all out smoothing the engine bay out!

Those #'s by the hinges shouldn't matter. You just need to keep the VIN #'s from the front aprons.

Steve

[Crazed]

We are going to spice in the vin plates from both aprons after the new ones are welded in, And are just going to remove those #s by the hinges.

[67cougnut]

great build! Followed!

[neongreen]

Nice!

[Crazed]

New Heater


Cool welding Pic


We are plating the "Frame" between the Mustang II front end and where a tranny crossmember/subframe deal was done before I got the car.

[Martin71RS]

Nice job on the new sheetmetal :-) cool car!

[Dave B]

Looks awesome!

[Crazed]

Fuzzy pic but you can see the plated framerail, and we boxed the support under the radiator


Inner fender welded in..lots of work in the rear outer section where the steering box used to be...much cleaner now


Front area where the strut rod used to be.

Flange for the core support




Passenger side


Inside look



Outside again