Results 1 to 5 of 5
Thread: )9 Camaro rear axle
Hybrid View
-
08-21-2013 #1
Registered User
- Join Date
- Dec 2008
- Location
- Dardenne Prairie, MO
- Posts
- 48
)9 Camaro rear axle
Would a 47" width axle flange to axle flange be to narrow with a typical minitub? Was hoping to buy already narrowed.
-
08-21-2013 #2
Registered User
- Join Date
- Aug 2009
- Location
- Charlotte, NC
- Posts
- 171
I have always been advised to start with your wheels and brake setups to then figure the housing and axels from that.
08-21-2013 #3
Registered User
- Join Date
- Apr 2011
- Location
- Hanceville, AL
- Posts
- 1,322
I'm not sure what year Camaro this is for, but it seems a bit narrow. 2" narrowed per side is a good starting point.
08-21-2013 #4
Registered User
- Join Date
- Apr 2004
- Location
- OKC, OK
- Posts
- 3,739
way to narrow
Mike Redpath
Musclerodz & Customz
405-288-0189
pro-touring parts specialists
Musclerodz.com
facebook page
http://www.facebook.com/#!/pages/Mus...73054649402015
instagram
Musclerodz
08-21-2013 #5
Registered User
- Join Date
- Apr 2012
- Location
- Woodstock, IL
- Posts
- 2,410
)9 Camaro rear axle
You don't need a narrowed rear end for minitub.. That just gives you a deeper dish on the wheels.
-DaleSchwartzPerformance
The leader in bolt-in muscle car chassis
SchwartzPerformance.com | GMachineChassis.com | Facebook | Twitter | Instagram
Dealer for: Forgeline, RideTech, Tremec, American Powertrain, Silver Sport Transmissions, GM Performance Parts, RECARO, Cerullo Seats, TMI Products, Vintage Air, Baer Brakes, Wilwood, BeCool, AFCO, Tanks Inc, Holley / Hooker, Ultimate Headers, Rick's Tanks, Moser Engineering, Currie, TechAFX, Stainless Works, II Much Fabrication, and many more
Reply With Quote
