Basic steps for paint...

[bs46488]

Been searching for the last 30 mins and couldn't find any similar posts.



I've been slowly stripping about 6 paint jobs off my car. After I stripped each panel, I put a slight layer of rattle can primer. I've cut out the major rust areas and welded in some patch panels, etc. Now I'm ready to start "prepping for paint". Is this the general process I should follow?

1. DA sand off rattle can primer
2. Epoxy primer
3. Body work/filler
4. 2k poly filler primer
5. block sand and repeat
6. base coat (color)
7. clear coat
8. cut and buff

I'm not looking for any show quality paint, I'd be happy with a 20 footer or better.