Results 1 to 20 of 121
Thread: 1970 Trans Am Project
Hybrid View
-
01-05-2014 #1
Registered User
- Join Date
- Apr 2012
- Posts
- 385
Well I had to make an updated Pushrod. The first pushrod was made out of aluminum and that could possibly bend under the force of the brake pedal. Here is an updated video showing the new pushrod (and the new steel sleeve I made
)
The new pushrod is all hardened steel. The CNC Master cylinder just has a tube that the pushrod slips into. Pushrod goes into the hole about 1.5 inches and bottoms out. Once the other end is connected to the brake pedal there is no way it can slip out. Check out the new video. New Bolt holding pushrod to pedal is 3/4 inch, that won't break
-
Reply With Quote
