Will a Wilwood master cylinder work with the ATS T-56 install kit

[dirtymaro68]

Hi looking for help im wanting to run a wilwood MC with the ATS T-56 install kit im gonna be running a 383 stroker with a T-56 just wondering if a wilwood MC will work and any advice or part #s would be greatly appreciated.



Thanks
Louis

[dipren443]

Physically, yes it will work. I have since changed my plans, but it did all bolt up. All I did was slot the mounting holes on the ATS firewall bracket to get everything to line up perfectly.

[dirtymaro68]

I like the way the wilwood mcs look do you think that would be the ideal way to go and will work fine.

Thanks
Louis

[dirtymaro68]

Planning on buying my master cylinder today off a fellow member just wanted to ask your guys opinion and if this is the right size for me. Appreciate the help Thanks guys. Its the 7/8s bore.http://www.jegs.com/i/Wilwood/950/26...0002/-1?CT=999

[Apogee]

Planning on buying my master cylinder today off a fellow member just wanted to ask your guys opinion and if this is the right size for me. Appreciate the help Thanks guys. Its the 7/8s bore.http://www.jegs.com/i/Wilwood/950/26...0002/-1?CT=999

You'll need to let us know what brakes you're running to be sure, but the 7/8" bore units tend to work well in manual installations with aproximately 4 and 2.5 square inches effective caliper piston areas front and rear respectively with a 6:1 pedal ratio. This includes many aftermarket brake kits including C5/C6 based stuff like we sell.

Tobin
KORE3

[dirtymaro68]

Im not exactly sure what kit yet, but im gonna be running a wilwood 6 piston kit front and rear im also gonna be going with the speedtech subframe with ATS tall spindles. Help is much appreciated.

Thanks
Louis