Custom Fender Liners

[THE TECH]

Not sure where to post this. I am looking to get some custom inner fender liners done in the Southern California area for my 1970 Chevelle. Any place come to mind?

[THE TECH]

As a side note to this, are people running the stock fender liners to get these low stances, modifying them or just removing them altogether? I did some searching here and can't seem to find any info.

[CrawfishPSD]

I'm in the same boat sir. I've been looking as well, and haven't found any clear info on what we're looking for. I want to run the liners cause 90% of the time the car will be in the rain and on the street rather than the track, trailer or garage. I wish I could that but I can't.

[DarkoNova]

I tried modifying mine because my tires actually hit them if I go too fast through dips or over speedbumps, but it didn't help. I'm probably just going to take them out. I know Anvil makes some wider than stock ones for Camaros, they might have some for Chevelles, too.

[THE TECH]

I tried modifying mine because my tires actually hit them if I go too fast through dips or over speedbumps, but it didn't help. I'm probably just going to take them out. I know Anvil makes some wider than stock ones for Camaros, they might have some for Chevelles, too.

That doesn't give me hope.

At $800 for the cheapest set, the Anvil ones are probably out of reach for what they are.

Gonna get the fenders rolled and see what kind of room that offers.

[THE TECH]

No other suggestions here? There are plenty of Chevelle guys here that are going lower than I. There has to be some sort of solution on this.

[THE TECH]

Anyone?

[The WidowMaker]

going custom on mine. i hope to split the stock ones and use the outers and make custom inners. but i havent gotten that far to see if the outers will provide enough clearance. i'll have something figured out in a few months.