Results 1 to 3 of 3
Thread: Rechromer
-
05-10-2005 #1
-Moderator/Rat Pack/Sponsor-
- Join Date
- Oct 2004
- Location
- Macon, Ga.
- Posts
- 8,085
Rechromer
Any suggestions/recommondations for a good rechromer in the southeast. I have some trim pieces on the Lemans that need some attention and being able to find replacements isn't looking too good. Most of the stuff is potmetal.
Thanks
Last edited by Bill Howell; 05-10-2005 at 02:54 PM.
Bill
Trailers are for BOATS!
-
05-10-2005 #2
Registered User
- Join Date
- Aug 2004
- Location
- Central Florida
- Posts
- 486
Bill,
You might want to check out these people http://www.advancedplating.com
They are in Tennessee too. If I remember right I think they were at our Turkey Rod Run in Daytona this past year and they do potmetal work also. I haven't used them so I dont have an opinion on their work, but some of their samples looked very good.
Jack
05-10-2005 #3
-Moderator/Rat Pack/Sponsor-
- Join Date
- Oct 2004
- Location
- Macon, Ga.
- Posts
- 8,085
Thanks Jack,
I had their card but lost it. I knew there was a place in Nashville, and could not find their info.
Thanks again,Bill
Trailers are for BOATS!
Reply With Quote
