Question on my 69 camaro interior

[jtm311]

So on Sunday after the snow I was at a friends towing company, he picked up a 2001 Trans am which will be a total write-off. The back off the car is gone from the accident. He buys many off these cars from the insurance and sells them to yards or parts them out.

For my question, has any one looked at putting this interior into a 69 camaro? I think I could make most of the interior fit.

If I work a deal for the whole car there is a LS1 and manual in it, who knows what I could do with it all

Also, picked up a full set of gauges for $25.00 which was left in a theft recovery, not bad looking.

John

[SamHatco]

I would do a search on 4th gen dash in 1st gen camaro. There are several guys that have done the mod.

Sam

[jtm311]

Thanks Sam I searched but never used "4th Gen" I thought I would be the first

John

[NYTRANSAM]

Thanks Sam I searched but never used "4th Gen" I thought I would be the first

John

high performance pontiac magazine featured a 69 convertable firebird with a 4th gen dash and center console. It was a few months ago not sure what month it was?

[jtm311]

high performance pontiac magazine featured a 69 convertable firebird with a 4th gen dash and center console. It was a few months ago not sure what month it was?

Thanks I will look for it.

John

[69Cam620]

Not doing a full T/A interior but am using the front seats from a 97 T/A. Thought you'd like to see. The T/A sliders aren't a direct bolt in, but with a welder I took the 69 mounts and welded to the 97 sliders and used an old bed rail for extra metal material. The seat height etc is perfect. Now just need to figure out how to wire the two so that the inflatable bolsters work.

[jtm311]

Looks good Can't wait to see her done.

Did you have change the sliders?

John