custom PCV / breather / system

[Provertstang]

Looking for a cool set-up for a PCV/breather. Something like a circle track set-up. I have sheet metal valve covers without holes. I have seen a set-up with 10an bungs welded in the valve covers and braided lines going to the rear of the motor with a horizontal aluminum tank mounted to the firewall. A 10an fitting in each end of the tank with 2 K&N breather filters on the top.


Does this make sense?

Pictures of your custom set-up would be greatly appreciated.

Thank you,
Brent

[BADVELLE]

Check this one out, I was looking at doing something this way. I am note sure what he is doing now, but I got this picture and idea from Matt @ Lateral Dynamics (back when he was doing some stuff on the side).