PDA

View Full Version : Aftermarket rear spoiler?


TonyHuntimer
08-01-2006, 09:36 PM
Hey guys,

Is anyone aware of a rear spoiler for a first gen that is about an inch taller than the stock first gen spoiler?

Thanks,
Tony Huntimer
RaceHome.com
TSSPAYNE69RS
08-04-2006, 11:20 AM
I like one an inch taller also but don't know if or where they can be found.
ilovefirstgens
08-04-2006, 05:55 PM
Just do it yourself!

Step one get stock height spoiler
Step two apply giant goup of bondo to the top
Step three sand until it looks good!

And whalaa custom spoilerness


Oh and just to add to the thread I had been thinking about one 1" or so shorter, with the center section bonded to the trunk lid and the ends still free, I think it would look sliiick.
BA.
08-04-2006, 06:20 PM
Just do it yourself!

Step one get stock height spoiler
Step two apply giant goup of bondo to the top
Step three sand until it looks good!
And whalaa custom spoilerness

Oh and just to add to the thread I had been thinking about one 1" or so shorter, with the center section bonded to the trunk lid and the ends still free, I think it would look sliiick.


well obviously you should cut out your inch and give it to one of the other guys!! :lmao: :thankyou: I'll be here all night. :rotfl:

.
harshman
08-04-2006, 07:11 PM
i thought ATS was going to make a rear spoiler someday. the demand is there.
Steve1968LS2
08-04-2006, 07:20 PM
i thought ATS was going to make a rear spoiler someday. the demand is there.

Soon.. but it's not taller.. just nicer in other ways :)
harshman
08-04-2006, 07:41 PM
i know. just trying to get some hype going. tyler was telling me about it about 2 years ago. if i end up getting one, what am i going to do with the Mc D's paint job?
vintageracer
08-05-2006, 06:06 AM
Years ago I made a new base that was 1 1/2 inches taller upon which I bolted a stock spoiler. The base was contoured to fit and accent the stock spoiler contours. It worked GREAT!

Spoiler base was mocked up using balsa wood and bondo. Made a mold and made a fiberglass base. Spoiler mounted to base with stock mounting bolts and base mounted to trunklid using stock holes in trunk lid.

This was easy to do and looked great! I cannot find any pictures of the base and the mold is long gone. Sounds like a nice new project for someone!