morbid creations
06-30-2006, 03:06 PM
ok... so i have built a frame to hold my jig... and my plan is to use pins to locate my panels in the correct location for the fisher body specs... now my question is are all the holes that are used for reference points 5/8ths in size? because i have already cut my floor trunk and frame out... and i noticed on my new fire wall piece it looks like the reference hole is 5/8ths... but on my frame rails there are three holes one is 5/8ths one is smaller and one is slotted.
and LOOONNNGGG WEEEKKKKEENNDDD is HEEEERRRREEEE!!!!!!!!!!!!!!
:firefire:
and LOOONNNGGG WEEEKKKKEENNDDD is HEEEERRRREEEE!!!!!!!!!!!!!!
:firefire: