Results 1 to 9 of 9
Thread: Need some seat bracket ideas
Threaded View
-
10-23-2020 #1
Registered User
- Join Date
- Feb 2013
- Location
- South Carolina
- Posts
- 935
Need some seat bracket ideas
Maybe fabrication? I'll start here.
I wasn't happy with how my seats were mounted to the floor. To be fair, I was in a bit of a rush to get ready for a power tour, but now that it's time for a nice paint job, I want to redo them. That was a fun talk with the spouse. "I'm not happy with the seat mounts." "Why, they work fine?" "Yes but I'm not happy with it..." And so on.
Anyway, I need the seats back from factory about 3" for my height and the floor is not level or flat in any direction. Here's what I have to work with after cutting out the previous mounts:
I want the bracket about here with a little downward rake but not as much as the floor. The front outside bolt hole is right in line with where I need it but the back comes up way short:
FWIW, these are Corbeau brackets/seats. I don't might cutting and welding to get this done but I'm struggling with how to get a clean, simple solution that I can lay carpet over/around and not have it looked hacked up. Thoughts?
-
Reply With Quote
