Custom made A/C hose ??

[DT69Cam]

Anyone know of a good source for custom A/C hose made to your specs ?? Thx

[Bad Bowtie]

Look into EZ Clip by Eaton / Aeroquip... Vintage Air sells these kits to make up your own lines without crimping. Very easy to use and saves a lot of time and makes it easy to "clock" your fittings. They are a little pricey but I think worth the money for time saving and a lot less aggravation.
BB

[GoodysGotaCuda]

I was able to borrow a crimp tool and DIY it, it's not too bad of a process if you can get ahold of a crimper.

[csouth]

If you have a Pirtek near you, I would buy a kit from an AC vendor and make them myself. Clock them, mark, then take them in for crimping.

[badazz81z28]

Anyone know of a good source for custom A/C hose made to your specs ?? Thx

What Di you need? I can make you one. I have the proper crimper and fittings.

[DT69Cam]

What Di you need? I can make you one. I have the proper crimper and fittings.

I only need an 11 1/2 inch piece overall (end of straight fitting to end of 90 fitting) I was going to have a shop custom bend some tube because I was afraid the hose would not bend in a tight radius before kinking. 1 straight female o-ring #10, and 1 90* female o-ring #10.

[DT69Cam]

I only need an 11 1/2 inch piece overall (end of straight fitting to end of 90 fitting) I was going to have a shop custom bend some tube because I was afraid the hose would not bend in a tight radius before kinking. 1 straight female o-ring #10, and 1 90* female o-ring #10.

I just double checked the measurement. Its actually 8 inches long overall.

[LemonTwisted]

If you go with the EZ-Clip hose and ends check out HoseWarehouse.com. Their prices are much cheaper than the A/C specialty places.

[csouth]

I only need an 11 1/2 inch piece overall (end of straight fitting to end of 90 fitting) I was going to have a shop custom bend some tube because I was afraid the hose would not bend in a tight radius before kinking. 1 straight female o-ring #10, and 1 90* female o-ring #10.

So what you actually need is a custom fitting not hose?

[DT69Cam]

So what you actually need is a custom fitting not hose?

No, No, one end of the hose will have a straight fitting on it, the other end of the hose will have a 90 degree fitting on it. Anyway, thanks for the replies guys. I found a local place that made it up for me.

[OLDFLM]

My local NAPA does it... maybe check locally?

[badazz81z28]

I sent you a PM. I have a hose, just need the length and I can put the fitting on it.

[TheJDMan]

I used to work for NAPA and most stores have the equipment to make up custom AC hoses.

[Zspoiler]

Have you tried your local "AC" shop.