Looking for a nice clean wire routing clamp.

[Auto Rod Technologies]

I am looking for a nice way to run the wiring down the side of the frame rail. I really don't wan to use zip tie clamps, or the strap clamp things, which I have used in the past.

The frame is not boxed in so i would like it to look good from both the outside and inside of the frame rail, so a push through clamp isn't working for me.. I would at least like something I can put a stainless nut on the back side.

Any thoughts appreciated.

[Schwartz Performance]

How about billet line clamps for fuel lines?

-Dale

[Auto Rod Technologies]

As of now that is what I am leaning towards.. I was planning to use notchhead line holders for the stainless air lines on this project but it leaves the end open so it wont' work for the electrical.. So now I may use the billet specialties for everything, but looking for other options.