Finished Rear End Brake Line Clips

[Brian - JCG]

If you were to make a set of these with the round hoop for the brake line fitting replaced with a square type just like the weld on fitting, I think you would have another big seller on your hands. Just make the pass through of the square fitting a bit larger so the most popular line sizes could each be used in it with a rubber insert, ( almost like a 3/8 inch wide section of vacuum hose with an ID the same as the different lines.

Good idea, might be an thought for a future product. Thank you

[Brian - JCG]

These clamps are convenient for the vehicle with the finished rear end, when welding can't be done without ruining the finish.

[BK2LIFE]

We are fully stocked on these......

7 years later, i see these are still in production, i'm ordering 4 sets right after xmas