Chevelle with GTO seats Rear deck

[1badchevelle]

if you are asking for the front I used these brackets on the rear part for the seat.

[AZSaleen04]

Yes it is what I'm asking about. What are they and where did you get them from?

The seat tracks bolt to these and the plate are only attached to the back bolts? Any ohter mods needed to mount these?

Thanks

[1badchevelle]

These are made from aluminum. the seat brackets bolts threaded bolt holes the oval ones mount to the car. You can drill you own holes to make it work. I am not done just need a bit of trimming on the seat bracket.

[AZSaleen04]

Where did you get them from and what application are they for?

Thanks

[1badchevelle]

they came with my seats, brackets are for a 2nd gen camaro but worked out,Maybe I can have some made

[bearwater]

Greeding from Kandahar AFGHNISTAN,


Hello to everyone out there, I am writing to see if anyone know how to get in touch with Shannon Walters of Interiors By Shannon. I tried the email address [email protected], with no responce, wanted to see if he makes and sell the console in the Black 71 chevelle with red interior on his wedsite. I wanted to put the same console in my 70 chevelle, but with 04-06 GTO seats, or if anyone knows of a simular console out there. If anyone can help, I really would appreicate it.

From AFGHNISTAN

"ONE TEAM ONE FIGHT"

[leadsled 65]

For the guys with 65 to 67 A bodys here a link that might help u
http://www.classicresto.com/mambo/co...iew/55/2/1/12/

[Slow1]

Here is a link to an install of the GTO seats it is for a 68 GTO but same concept. Hope this helps.
http://1badgto.com/seats.aspx

[jhester66]

Thanks for all the info, sure has helped me make up my mind to do this swap. Just a quick idea for the gap left on the sides, I have a set of arm rests for a 66 convertible which are about 3.5 inches wide, I think these would fill the gap nicely. My car is a sedan but somewhere down the line these along with a convertible bench were installed for some reason. I am definately going to do some more detailed measuring, I think along with a wider center section and the vert. armrests the seats would fit nicely. Thanks again for the great info and pics....I will post some pics of my arm rests, may help someone come up with a idea for fabrication.

[brans72]

good info here guys.

[chuckd71]

Has anyone with a convertible gotten around to this yet?