Project FNQUIK

[Tincup]

I have the tool for crimping AC lines, just in case...

[Motown 454]

Thanks I appreciate both your help, I’ll mention it to him tomorrow. Thanks guys.
Thanks Mike, I'm using the EZ Clip fittings.

[icemanrd19]

Why not mount the dryer where they are normally mounted on the condenser? Why not put the charge ports by the AC compressor for easy access?

[Motown 454]

The dryer won't fit because of my inter cooler hoses. That's where they're going to go.

[icemanrd19]

Ok. I was able to route mine without any issues with the c&r heat exchanger.

[icemanrd19]

[Motown 454]

How close are your RS doors when their open?

[icemanrd19]

Really really close lol. It would actually touch the upper heat exchanger hose but I added a stopper so the door wouldn’t fully open the entire way. The door still goes out of sight. I could easily move the condenser over slightly if I wanted to but I’m happy with the set up.

[blitzer454]

I did the same as Randy except I ran my intercooler hoses down and around to under the passenger fender which is where I mounted the pump. I can fit a piece of paper between the head light door and the hoses but nothing much wider.
Here's some pics: pic1, pic2, pic3

[Motown 454]

It looks good.

[Tincup]

Hey Wayne, I happen to have an extra AC condenser if you need one.

[Motown 454]

Thanks Mike I have one it came with the A/C kit.
Are you sheltered at home? Getting any time on the truck?

[Motobrewmaster]

Hey Wayne. Car is looking great! Where you at in MA? I am only up in Portsmouth so not to far away. Trying like the devil to get my car on the road to enjoy it this summer.

[Motown 454]

South coast. Near the Rhode Island line. I’d like to at least get it running and maybe take a few rides to break in the motor.

[Tincup]

Thanks Mike I have one it cam with the A/C kit.
Are you sheltered at home? Getting any time on the truck?

Yep, i'm home, getting some work done on the truck, starting the wiring.

[Motown 454]

Be glad you have the truck to keep you busy.

[Motown 454]

I got a few pictures of the progress so I figured I'd post them.
Not sure if I posted this yet. Changed those long harpoon screws that come with the fuse block, I got enough scars from them working in the engine bay.




Wiring all run to the front for the inter cooler pump, lights ,RS doors and fans.


DSE Wiper motor is mounted and wires ready to connect.



Evaporator installed and plumbed.



A/C Hoses routed over the inner fender.



And some of the Dakota Digital boxes mounted with in reach. The cruise control is mounting over the brake pedals.

[andrewb70]

Nice!

[Motown 454]

Thanks Andrew

[wfo guy]

It's about to get full.