Location for 3/8 brushless fan water temp sensor

[Vimes]

They took long enough to respond. Anyone with a fan they can't use an ECM on and doesn't have its own built-in controller, DCC Controls is the way to go.

brian

From:
[email protected]
To:
Vimes
Fri, Jun 14 at 12:33 PM



It will work on a brushed and brushless fan, it wont work on a fan with an internal pwm

[dhutton]

They took long enough to respond. Anyone with a fan they can't use an ECM on and doesn't have its own built-in controller, DCC Controls is the way to go.

brian

From:
[email protected]
To:
Vimes
Fri, Jun 14 at 12:33 PM

It will work on a brushed and brushless fan, it wont work on a fan with an internal pwm

You mean like this one that specifically states can’t be used with PWM controllers?
https://www.summitracing.com/parts/pro-67035

A brushless fan will still have a multiphase inverter and it’s going to get quite pissed off if you connect it to a DCC PWM controller. Perhaps DCC could supply details of brushless fans that work with their controller….

Don

[dhutton]

For those who are interested here is some good information on how brushless DC motors operate and how they are controlled. It’s complicated….
https://www.renesas.com/us/en/suppor...r-01-overview#
https://www.renesas.com/us/en/suppor...2-inverter-pmw

Don

[CarlC]

The brushless fans that are three wire (bat+, bat-, pwm signal input) cannot be used with the DCC (or PSM/vaporworx) brush-type controller. Basically any brushless fan motor that needs a PWM control signal.


For brushless fans that do not have the logic built in (two wire) there is a very good chance that the DCC controller will work well. It does work on other similar brushless motors such as those used for water pumps. A bit of experimentation would be needed but with a high likelihood of success.


But, if given a choice, the OEM or Spal brushless fans with built-in logic would be my first choice. They are worlds better than the aftermarket 12v-on brushless fans. Control can be done with an OEM ECM, many aftermarket ECM's (Holley), or a DCC/PSM/VaporWorx stand-alone brushless fan controller.

[Vimes]

Ehh, that was what they sent me, that's all I can do. I moved on to ECM control years ago so can't say one way or the other.