2nd gen camaro speedtech torque arm

[chevelletiger]

I have a partial speedtech torque arm,I'm really testing the water 1st to see if I can get what I want for the parts,I bought the parts
Used to retrofit into my chevelle

I did cut the lowers control arms and made them straight.
The fixed ridged arms didn't play nice with the the chevelles,
Lca lower frame mount that are at an angle when I cycled the suspension during mock up.

I'll include the tube that were cut new tubes can easily be bent and rewelded its just 1.5 .120 wall Dom.

The kit is missing the panhard bar frame mount,axle mount,and has a partial crossmember.

I'm planning on using it with my 12 bolt but I'm not convinced the axle clamp is ideal with this in the 12 bolt.

If it doest sell then I'll make something that mounts to the ears of the 12 or have bolt on bracket ls to the TA and webs of the SpeedTech TA.

pictures below

Asking
$1600. Local pick up preferred. But Shipping would be expensive.

Location is south corona ca.
Thanks guys.

[chevelletiger]

A picture of what the link has to swivel if anybody was ever wondering.
Pretty simple thread idea.
I feel it's only good in a parallel format,not good witharma that are at an angle out work,just my opinion.

[chevelletiger]

Changing direction.
I'm going to sell the TA after all.
Been pondering the time involved to retrofit this,a friend wife just got diagnosed with B-cell lymphoma and it's next to her heart.
Since I'm doing the ly6 LS swap,I don't need more on my plate.

Life is too short,and I see it easier to just redo the rear crossmember upper control arm pickup point,just cut out the oe plate pockets,and welded them in.



New price is $1,000 obo
Sorry for the long post,just needed to say it.
As i was under the car,I said to myself "I need to start racing this thing,and this is adding more time"

My step kids grandpa passed too this week so...
I'll be posting it local.
Phil

[chevelletiger]

Make an offer guys.
I'm most likely going to modify my upper crossmember mount holes or doba 3 Link later on when I get a 9 inch

[chevelletiger]

Reasonable offer.
What this out of my family room!

[raustinss]

Lmao im sure your wife also wants it outta the family room .. cheers glws

[chevelletiger]

Lmao im sure your wife also wants it outta the family room .. cheers glws

Hahaha she doesn't mind.
He'll I have the 6.0 rods and pistons sitting on the dining table,there clean though!

[chevelletiger]

Bump price drop this week 850 plus shipping or pick up locally

[chevelletiger]

Bumps $700.00 plus shipping or local pick up

[chevelletiger]

Bump,price drop.
$650.00
Can believe someone doesn't want this???

[TANKMASTERJ]

Wonder what shipping would run to 72106

[vcho455]

bump,price drop.
$650.00
can believe someone doesn't want this???

Must
Not
Change
Direction
Again!!!!!!




Sorry it's awfully tempting but...

[chevelletiger]

I would have to box it up to get a price.
Sorry I haven't been on the site fixing z06 LS7 problems!

- - - Updated - - -

Change directions! I need this gone.

[David Sloan]

Sent you a pm
Thank you sir

[chevelletiger]

David,I didn't get it send it again please.

[David Sloan]

Thank you sir!
Good talking to you.